Allied Telesis x330 Series, Руководство по установке

Страница: 78 / 126

Chapter 6: Installing the x330-10GTX Switch on a Wall
78
Installation Guidelines
Here are the guidelines to installing the switch on a wall:

As shown in Figure 41 on page 76 and Figure 42 on page 77, the
BRKT-J23 brackets secure the device by its sides. Installing the
brackets over the front or rear panel will block copper ports or the
AC power connector.

Installing the switch with two brackets requires one BRKT-J23
bracket kit. Installing the switch with four brackets requires two
BRKT-J23 bracket kits.

The BRKT-J23 bracket kit does not include screws or wall anchors.

You can install the switch on a wooden or concrete wall.

The diameter of the screw holes in the brackets is 4mm.

You should not install the switch only on sheetrock or similar
material. Sheetrock might not be strong enough to safely support
the device.
Warning
The device should be installed on a wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is not properly fastened to the wall.

E105
Warning
The device is heavy. Use both hands to lift it. You might injure
yourself or damage the device if you drop it.

E94