OmniConnect / ISDN
User’s Manual
Page 56
Part number 613-10787-00
6.3.10.
LAN IP configuration
Enter the
LAN IP Address
,
Gateway IP Address
and
DHCP Server Configuration
using
this screen. The OmniConnect series access devices use default IP address of 192.168.1.1 for
their
LAN IP Address
and
Gateway IP Address
. For most applications, the default values of
these parameters will not need to be changed. We recommend that both of these values
remain at their default values. If, however, it is necessary to alter these defaults, deselect the
Default check box and enter the
IP Address
,
IP Subnet Mask
and
Gateway IP Address
Configuration
parameters.
The
Gateway IP Address
parameter normally must be the same as the
IP Address
parameter. Normally, the OmniConnect modem access device is the Gateway for its clients as
well as the DHCP server. In the case that the OmniConnect access device is used as a DHCP
server and not as the outgoing Gateway, the
Gateway IP Address
parameter should be
changed to that of the outgoing gateway. The DHCP Server will then assign the Gateway
Address to each of its clients. The Gateway IP Address and the LAN IP Address should
normally be attached to the same subnetwork.
The
DHCP Server Configuration
allows the enabling or disabling of the built-in DHCP
server. The OmniConnect access devices can act as a complete DHCP server, assigning all the
IP addresses to all the local computers connected on the LAN. Checking the DHCP Server
Enable check box and entering a Starting IP Address and Number of Addresses count enables
this feature. Checking the DHCP Server Disable check box disables the feature.
The DHCP server automatically assigns an IP subnet mask to its clients based upon the setting
of the
Number of Addresses
parameter. The mask is calculated according to the following
table.
Содержание OmniConnect/ISDN
Страница 1: ...User s Manual OmniConnect ISDN OmniConnect ISDN Internet Access Device...
Страница 6: ......
