Allied Telesis OmniConnect/ISDN, Руководство пользователя

Страница: 38 / 91

OmniConnect / ISDN
User’s Manual Page 32
Part number 613-10787-00
5.3. OmniStart configuration
The installation process automatically executes the OmniStart configuration program after a
series of files have been copied onto the computer. The opening OmniStart Welcome screen
shown below appears. This is the first in a series of screens that are used to install and
configure the OmniConnect access devices. Progression from screen to screen is
accomplished by clicking on the
Next> button at the bottom of each screen. Installation and
configuration may be canceled at any point by clicking on the Cancel button.
The OmniStart program has the capability to detect and operate correctly in an environment
where multiple OmniConnect access devices of the same model are present. When the
OmniStart program is invoked, the utility scans the network for connected OmniConnect
access devices. If multiple access devices are detected, OmniStart prompts the user to enter
the IP address of the access device that is to be configured. After the IP address is entered,
execution proceeds as normal.
5.4. OmniStart screens
The OmniStart configuration and setup utility has a number of screens. In most cases the on-
screen setup instructions should be followed. This section documents the functionality of the
mandatory screens that the user must fill. The advanced screen functionality is documented in
the next chapter.
5.4.1. Welcome screen
The Welcome screen is the very first screen of the OmniStart configuration and setup
application. This screen contains information about prerequisites for the setup and
configuration program. Please read and follow the instructions on this screen to ensure that
the OmniConnect access device setup proceeds smoothly. Press the Next key to proceed with
the
OmniStart setup.