AT-WNP300N IEEE802.11b/g/n 1T2R Wireless Fast PCI adapter User Manual
23
Figure 25: Active a WEP Network
Note:
Hex code uses 0-9, a-f characters; ASCII code uses 0-9, a-z characters. All settings must
be exactly the same with the wireless AP; otherwise it will result in a failure.
Connect to a WPA-PSK/WPA2-PSK Network
Please perform the following procedure to connect to a WPA-PSK/WPA2-PSK network.
1.
In “Network” tab, select the AP you want to connect to, and then click on “Add to Profile”.
Figure 26: Select a Network
2.
In “System Config” tab, give the profile a name to identify.
Figure 27: Configure Profile
3.
In “Auth.\Encry.” tab, confirm that the Authentication and Encryption setting is corresponding to the
wireless AP. Input the Key and then click on “OK” to apply the settings.
Figure 28: Configure Auth./Encry.
4.
In “Profile” tab, select the profile you want to connect to, and then click on “Activate”.
