Allied Telesis AT-GS2002/SP, Руководство по установке

Страница: 40 / 52

Chapter 2: Installation
40
Cable Installation
Observe the following guidelines when connecting twisted-pair and fiber
optic cables to the ports on the media converter:

The cable specifications for the twisted-pair ports are given in
Table 1 on page 20.

The cable connector should fit snugly into the port on the media
converter. The tab on the connector should lock the connector into
place.

Because the twisted-pair ports have auto-MDI/MDI-X, you may use
straight-through or cross-over twisted-pair cables to connect any
type of Ethernet network devices to the media converter.

Refer to the cable specifications included in the SFP module data
sheet for the SFP module installed.
Connecting to the
Copper Port
To connect to the RJ-45 twisted-pair port on the AT-GS2002/SP Media
Converter, perform the following procedure:
1. Connect the RJ-45 twisted-pair cable to the 10/100/1000Base-TX port,
as shown in Figure 8.
Figure 8. Connecting to the RJ-45 Copper Ports
When connecting a twisted-pair cable to an RJ-45 twisted-pair port,
observe the following guidelines:

An RJ-45 connector should fit snugly into the port on the converter.
The tab on the connector should lock the connector into place.

You can use a straight-through or crossover twisted-pair cable to
connect any type of network device to a port on the converter.
2. Then connect the other end of the RJ-45 cable to the link partner.
3. Connect the fiber cable to the SFP module as described in
“Connecting to the SFP Module” on page 41