AT-FS232 and AT-FS232/x Series Installation Guide
27
Warning
When installing this equipment, always ensure that the frame ground
connection is installed first and disconnected last.
16
Figure 15
Connecting the Stripped Wire
6.
Connect the
negative
feed wire to the terminal block marked (
-
).
7.
Connect the
positive
feed wire to the terminal block marked (
+
).
8.
Connect the other end of the wires to the terminal block on the
AT-PWR237 power adapter or approved SELV power source per IEC
60950 (rated minimum 12-50VDC, 0.5A).
Figure 16
Connecting the Stripped Wires to the Optional AT-PWR237 Power Adapter
Note
The optional AT-PWR237 module does not have a terminal for the
ground
feed wire. Connect the ground wire from the bridging converter
to the nearest chassis ground.
12-50VDC
2
1
3
4
1
2
2 2
PORT
10
100
HALF
FULL
OFF
ON
DUPLEX
MODE
AUTO
NEG
SPEED
(Mbps)
APS
POWER SUPPLY
MODEL NO.: AD-740-1150
/SCG
INPUT: 115V~, 50-60Hz, 1
A.
OUTPUT: 15V , 2
.6A
CAUTION:
F o r Indoor Use Only.
ADVANCED POWER SOLUTIONS
T E L : ( 9 2 5 ) 4
5 6 - 9 8 9 0
Use only with duple
x receptacle ha
ving center scre
w
Secure unit in place b
y receptacle co
ver screw
Cable type "DP-1" or "DP-2"
U
L
E142017
LISTED
I.T.E.POWER
SUPPLY
4Z38
REV-00
JX-01
RT
