Hardware Reference
53
C613-03092-00 REV J
WARNING: Bad board of
type <number> in
Expansion Bay <number>
Board personality of the given type in the given bay could not
be read. Possible causes include:
•
unprogrammed personality PROM on the board
•
faulty hardware on expansion or host board
For information about boards, see the
show system boards
command in the
Configuring and Monitoring the System
chapter in the Software Reference.
WARNING: Unsupported
board of type <number> in
Expansion Bay <number>
Software does not support the board of the given type in the
given bay.
Unit was rebooted because
of a system exception
The switch is restarting after a system exception. Depending
on the exception, you may need to contact your authorised
distributor or reseller.
Creating core file
system_
release-
number
.core...done
or
Creating core file
system_
release-
number
.core...failed
Displayed after the switch restarts itself, and indicates
whether system core information has been written to the
specified file. Each image file creates its own core file and
coredump. This information is loaded into RAM after a
system exception and before the switch restarts. Contact
your authorised distributor or reseller.
ERROR: Unable to read
fallback package
information
Information about fallback software is not available. Contact
your authorised distributor or reseller.
ERROR: Unable to read
preferred or temporary
install information
Information is not available about the type of install
indicated. The switch tries to start from fallback software. If
this fails, contact your authorised distributor or reseller.
ERROR: Failed to extract
product_apps.img from
package to RAM
The product application image could not be extracted from
the package file because the package file is corrupt or there
is not enough RAM.
Manually restart the switch with fallback software (for
details, see
“Overrides” on page 49
), and install another
base package.
If this error occurs while rebooting from fallback, contact
your authorised distributor or reseller.
ERROR: Failed to run
product_apps.img
The operating system could not execute the product
application image file.
Manually restart the switch with fallback software (for
details, see
“Overrides” on page 49
), and install another
base package.
If this error occurs while rebooting from fallback, contact
your authorised distributor or reseller.
ERROR: Phase 2 of Software
Manager startup failed -
rebooting to fallback
software
Software Manager is part of the system software that
controls startup of the product software.The install
information for it is invalid or the installed software is not
licenced. Therefore, the switch boots up from the fallback
software.
Message
Description
(cont)
