Troubleshooting
84
Testing Network Connectivity
This section describes how to test network connectivity for Windows and
Linux networks.
Note
When you are using the fiber optic port, both the adapter and the
switch must be set to the same speed and duplex mode. When you
are using the copper port, set both the adapter and switch to Auto-
Negotiation or the same speed and duplex mode.
Windows
To test the network connectivity for the Windows driver software, perform
the following procedure.
Use the ping command to determine if network connectivity is working.
1. Select
Run
from the Windows Control Panel
The Run command window opens, as shown in Figure 43.
Figure 43. Run Command Window
2. Type
cmd
and click
OK
.
3. Type
ipconfig /all
The command window opens, as shown in Figure 44 on page 85.
Содержание AT-2701FTXa/SC
