ALLIANCE UM202 series, Установка, эксплуатация и обслуживание

Страница: 20 / 28

Connect Inlet Hoses
To connect water service to a machine with hoses, use the follow-
ing procedure:
1. Before installing hoses, flush the building’s water system at
the machine connection valves for at least two (2) minutes.
2. Remove the two (2) plain rubber washers and two (2) filter
screens from the accessories bag supplied with the machine.
3. Install one (1) plain rubber washer onto one end and one (1)
filter screen into the other end of each fill hose. The screens
must be facing outward toward the water supply. Refer to
Fig-
ure 9 .
4. Screw hose couplings with the filter screens onto the water
supply faucets until they are finger-tight. Use the red color-
coded hose for the hot water connection and the blue color-
coded hose for the cold water connection.
5. Using pliers, screw approximately 1/4 turn.
6. Screw the coupling with the plain rubber washer of the red
color-coded hose (attached to the hot water connection) onto
the valve inlet marked with a red label. Screw the coupling
with the plain rubber washer of the blue color-coded hose (at-
tached to the cold water connection) to the valve inlet marked
with a blue label. Tighten to finger-tight.
7. Using pliers, screw approximately 1/4 turn.
IMPORTANT: DO NOT cross thread or overtighten
couplings. This will cause them to leak.
8. Hang hoses in a large loop; do not allow them to kink.
9. Turn on water supply and check for leaks.
10. If leaks are found, turn off the water, unscrew hoses and rein-
stall them until there are no leaks.
IMPORTANT: Turn off water supply whenever there
will be an extended period of non-use.
If additional hose lengths are needed or using hoses other than
those supplied by manufacturer, flexible hoses with screen filters
are required.
8
3
9
4
5
7
6
1
2
CAR45N_SVG
1. Cold Water Valve Inlet
2. Hot Water Valve Inlet
3. Rubber Washer (plain)
4. Red Fill Hose (hot)
5. Hose Coupling
6. Hot Water Supply Faucet
7. Cold Water Supply Faucet
8. Filter Screen (screen must be facing outward, toward water
supply)
9. Blue Fill Hose (cold)
Figure 9
Control Function Test
The machine should be cleaned after the installation is complete.
A function test should then be executed on the unloaded machine:
1. Check the power supply for correct voltage, phase, and cycles
to be sure they are correct for the machine.
2. Open manual shut-off valves to the machine.
3. Turn on electric power.
4. Check the lid interlock before starting operation:
a. Turn extract timer dial clockwise to the two minute mark,
remain for five seconds, and return dial to “off” position.
b. Once rotation has stopped press the lid release button and
open the lid to the extract-rinse compartment.
c. Attempt to start the machine with the lid open. The ma-
chine should not start.
d. Close the lid without locking it and attempt to start the
machine. The machine should not start.
e. Close and lock the lid and start a cycle. Attempt to open
the lid.
If the lid lock and interlock are not functioning properly, call a
service technician.
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
20 F8221501ENR4