505038
65
SECTION 6
Adjustments
53. LEVELING LEGS (Figure 56)
NOTE: Dryer should be installed on a solid and level
floor.
a. Place dryer in position, adjusting the legs until
dryer is level.
NOTE: Legs can be adjusted outside the dryer by
using a 1-1/4 inch size wrench, or from inside the
dryer (with lower front access panel removed) by
using a 1/4 inch drive ratchet with extension.
b. Keep dryer as close to the floor as possible. All
four legs must rest firmly on the floor so weight
of the dryer is evenly distributed. The dryer
MUST NOT rock.
IMPORTANT: DO NOT move the dryer at any time
unless the dryer is completely assembled. DO NOT
slide the dryer across the floor once the leveling legs
have been extended as the legs and base could become
damaged.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be reconnected
to ensure that the dryer is properly grounded.
WARNING
W001R1
To reduce the risk of serious injury or death
by carbon monoxide and other gases in gas
dryers, carefully read and follow all
instructions given in this section.
WARNING
Figure 56
D351SE3A
LEVELING
LEG
DRYER
BASE
