To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be reconnected
to ensure that the dryer is properly grounded.
WARNING
W001R1
505038
37
26. CABINET TOP (Upper Dryer)
a. While supporting the upper access panel, remove
two screws from bottom edge of upper access
panel. See Figure 4.
b. Gently lower access panel to disengage panel
locators from bottom edge of access panel. See
Figure 4.
c. Remove two screws holding bottom tabs on front
panel to lower dryer cabinet. See Figures 13
through 16.
d. Swing bottom of front panel away from lower
dryer to disengage hold-down clips and locators
from control cabinet.
e. Disconnect wires from door switch. See Figure 9.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
f. Remove two screws holding cabinet top to front
flange of cabinet. See Figure 26.
g. Lift cabinet top to a vertical position by hinging it
on the rear hold-down brackets. See Figure 27.
NOTE: While servicing, cabinet top may be raised
and hinged on the rear hold-down brackets or
supported against wall behind dryer.
Figure 26
CABINET TOP
HOLD-DOWN SCREWS
CABINET
TOP
D252SE1A
Figure 27
D352SE1A
REAR
HOLD-DOWN
BRACKETS
