Alliance Laundry Systems POCKET HARDMOUNT UW50P4, Установка и обслуживание

Страница: 14 / 28

Installation
F232158
12 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Figure 3
Figure 4
If the existing floor is not reinforced concrete a
minimum of 12 inches thick over a solid base, it will
be necessary to cut a hole through existing floor
approximately 5 feet square and excavate to a depth of
36 inches from top of existing floor. Slope the edges of
the hole outwards so that the hole is pyramid shaped.
Excavate under existing floor 5 inches beyond the
required 5 feet square all around. Refer to
Figure 4
where x = 5 feet.
Refill with 24 inches of well compacted clean fill dirt
topped with 12 inches of reinforced concrete. Imbed
mounting bolts or base frame when pouring concrete.
Make sure that the bolt threads extend 2 inches above
the floor level.
After the foundation for the machine has been
prepared and the concrete has cured, proceed as
follows:
1. Place the machine adjacent to the foundation. Do
not attempt to move the machine by pushing on
the sides. Always use a pry bar or other device at
the bottom of the machine. Remove the wood
skid.
PHM191N
MOUNTING BOLT LAYOUT
36 in.
(914 mm)
9 in.
(229 mm)
0.75 in.
(19 mm)
1.25 in.
(32 mm)
0.75 in.
(19 mm)
31.62 in .
(803 mm)
35.62 in.
(905 mm)
2 in.
(51 mm)
2 in.
(51 mm)
0.75 in.
(19 mm)
39.25 in.
(997 mm)
34.12 in.
(867 mm)
44.81 in.
(1138 mm)
34.56 in.
(878 mm)
10.75 in.
(273 mm)
10.69 in.
(271 mm)
4.81 in.
(122 mm)
FRONT
PHM518N
PHM518N
X = 5 FEET