Alliance Laundry Systems NX18BVPA6, Руководство по установке

Страница: 22 / 25

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
9001909
20
Electrical Installation
IMPORTANT: Electrical ratings are subject to
change. Refer to serial decal for electrical ratings
information specific to your machine.
IMPORTANT: Alliance Laundry Systems
warranty does not cover compounds that fail as a
result of improper input voltage.
The AC inverter drive requires a clean power supply
free from voltage spikes and surges. A voltage monitor
should be used to check incoming power. The
customer’s local power company may provide such a
monitor.
If input voltage measures above 240V for a 220V drive
or above 415V for a 400V drive, ask the power
company to lower the voltage. As an alternative, a
step-down transformer kit is available from the
distributor.
The AC drive provides overload protection for the
drive motor. However, a separate single or three phase
circuit breaker must be installed for complete
electrical overload protection. This prevents damage to
the motor by disconnecting all legs if one should be
lost accidentally. Check the data plate on the back of
the washer-extractor or consult
Table 6 for circuit
breaker requirements.
The washer-extractor should be connected to an
individual branch circuit not shared with lighting or
other equipment.
The connection should be shielded in a liquid tight or
approved flexible conduit with proper conductors of
correct size installed in accordance with the National
Electric Code or other applicable codes. The
connection must be made by a qualified electrician
using the wiring diagram provided with the washer-
extractor, or according to accepted European standards
for CE-approved equipment.
Use wire sizes indicated in Table 6 for runs up to
50 feet.
Use next larger size for runs of 50 to 100 feet. Use two
sizes larger for runs greater than 100 feet.
For personal safety and proper operation, the washer-
extractor must be grounded in accordance with state
and local codes. If such codes are not available,
grounding must conform with the National Electric
Code, article 250-95. The ground connection must be
made to a proven earth ground, not to conduit or water
pipes.
Electrical Connection
Figure 11
Remove the cover plate at the back of the machine.
Connect the power cable to the connectors.
Machine without Electric Heating
Connect 200-240V single phase (1AC) to the
connectors “N” and “L1”. The green/yellow grounding
clamp has to be the grounding wire “PE”.
Hazardous Voltage. Can cause shock,
burn or cause death. Allow machine
power to remain off for two minutes prior
to working in and around AC inverter
drive.
W359
WARNING
Hazardous Voltage. Can cause shock,
burn or death. Verify that a ground wire
from a proven earth ground is connected
to the lug near the input power block on
this machine.
W360
WARNING
Do not use a phase adder on any variable-
speed machine.
W490
DANGER
CFD28N
PE
L3
L2
L1
N
4A
3 K 380V + N
3 K 220V
220V