Alliance Laundry Systems LTZ87A*H0902 Series, Руководство по установке

Страница: 12 / 70

Installation
800941
10 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Before You Start
Tools
For most installations, the basic tools you will need
are:
Figure 1
Water
Washer needs two standard 19.1 mm (3/4 in.) water
supply faucets with a pressure between 138 and
827 kPa (20 to 120 pounds per square inch). For more
detailed information, refer to section on
Water Supply
Requirements .
Gas
Dryer is equipped for Natural Gas with a 3/8 in. N.P.T.
gas supply connection. For more detailed information,
refer to section on
Gas Requirements .
Location
Place the unit on a solid floor with an adequate air
supply. For more detailed information, refer to section
on
Location Requirements .
Exhaust
Use rigid metal duct and exhaust the dryer to the
outside by the shortest route possible.
NOTE: For more detailed information, refer to
section on
Dryer Exhaust Requirements .
Figure 2
Electrical
NOTE: Single electrical connection serves both
washer and dryer.
●
ELECTRIC UNIT
Dryer needs a 3 wire and ground, 120/240 or
120/208 Volt, 40 Amperes, 60 Hertz, AC single
phase electrical supply. For more detailed
information, refer to section on
Electrical
Requirements .
●
GAS UNIT
Dryer needs a 120 Volt, 20 Amperes, 60 Hertz,
polarized 3-slot effectively grounded receptacle.
For more detailed information, refer to section on
Electrical Requirements .
NOTE: 208 Volt heating element is available (as
optional equipment at extra cost).
D814I
1 Wrench
2 Screwdrivers
3 Pliers
4 Socket Wrench
5 Teflon Tape
6 Level
7 Duct Tape
1 2 3
4
5
6
7
SWD442
S