Alliance Laundry Systems LMA260_MICRO, Оригинальное руководство пользователя

Страница: 34 / 62

INSTALLATION
HANDLING, TRANSPORT AND STOR-
AGE
TRANSPORT AND STORAGE
WARNING
FORKS OF HIGH LIFTING TRUCK MUST HAVE SUF-
FICIENT LENGTH.
C192
Use a lift truck or a manual skid cart for handling with the ma-
chine in transporting package.
• If possible, leave the machine in the transporting package or
at least let it set on the transporting wooden skid until the time
of final installation on the foundation according the Chapter
"
MACHINE POSITIONING " of this manual.
Minimum length “X” of lift truck forks for machine
model
Figure 7
HANDLING DURING INSTALLATION
All activities can be done only by qualified personnel. Machine is
delivered to the customer in wooden packing or a wooden crate,
and protected with polyethylene film. The machine is attached to
the skid by means of four bolts.
To remove the machine to its final position follow these precau-
tions:
1. All passages and spaces the machine has to be transported
through at installation should be reasonably dimensioned to
meet the height and width of the machine including the pack-
age.
CAUTION
Never push, pull or press the components protrud-
ing from the contour line of machine (front part of
the machine, filling door, control elements, belt cov-
er, water inlet and outlet pipes etc.).
MAKE SURE THAT THESE COMPONENTS ARE SE-
CURED SO AS TO AVOID THEIR DAMAGE DURING
HANDLING AND INSTALLATION OF THE MACHINE.
NOTE: Make sure that the filling doors are secured to
avoid its opening during the handling.
• Lift the machine up by the fork-lift or by pallet trucks using a
transport skid to which the machine has been attached.
UNPACKING
• After unpacking, check if the machine has not been damaged
and if all the accessories are included according to your order.
Verify the machine model according to your order and the se-
rial plate located on the left upper side panel on the front side
of the washing machine, (load side view),
Figure 5 , Figure 6
and find corresponding information in the manual. The acces-
sories and the manuals are located inside of the drum, which
can be opened according to Chapter "
DOOR BLOCKING ".
• Before the machine locating to its place, remove the packag-
ing, loosen four nuts and lift the machine carefully up and re-
move the wooden pallet. It is possible to handle the machine
by the fork lift or the manual truck in such a way, so that the
forks would not damage the components located in its lower
part. The lift truck forks must be at least 10 cm longer than
the length of the washing machine frame,
Table 3 .
Minimum length “X” of a lift truck forks for individu-
al machine model [kg / lb / L]
26 / 57 / 265 and 33 /
73 / 332
44 / 97 / 442 and 66 /
146 / 663
900 mm / 35" 1100 mm / 43"
Table 3
SPACE REQUIREMENTS
REQUIRED MACHINE WORKING CONDITIONS
See Chapter “ TECHNICAL SPECIFICATION ”. The washer must
not be installed or stored in an area where it will be exposed to
INSTALLATION
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
34 Part No. D1612ENR3