TROUBLE SHOOTING AIDS
DOOR BLOCKING
WARNING
IF ANY DAMAGE OF DOOR SYSTEM HAPPENS, IT IS
NECESSARY TO PUT THE MACHINE OUT OF OPER-
ATION IMMEDIATELY AND INFORM THE PRODUCER
ABOUT THE DEFECT!
C221
DESCRIPTION OF OUTER DOOR LOCK FUNCTION
The door lock has been designed as a compact unit. Its function is
to secure the door against opening during the washing cycle. Un-
locking after a cycle completion will be made by: Pressing of
shining light of door loock button. By this the unlock is done and
it is possible to open the door. The lock has been blocked also
during the failure situations e.g. electric network black out, be-
fore and after the machine installation and you can unlock it in
case of emergency according to the procedure hereafter descri-
bed.
LOCK WITHOUT TENSION BEFORE THE PRO-
GRAMME START
The lock is secured after the door is shut. At this moment the
door is not openable.
MAIN SWITCH AND EMERGENCY STOP BUTTON ARE
SWITCHED ON
DOOR SHUTTING
The lock is secured after the door is shut. At this moment the
door is not openable.
DOOR OPENING
Unlocking after a cycle completion (unload side - clean side of
the machine) or before running a wash program (load side - dirty
side of the machine) will be made by:
Pressing of shining light of door button. By this the unlock is
done and it is possible to open the door.
CURRENT FAILURE DURING OPERATION
When the power supply has been interrupted during a washing
cycle the door lock stays in a blocked position and the door is not
openable.
UNBLOCKING OF THE DOOR LOCK IN CASE OF
EMERGENCY
If the power blackout takes too long, you can make an emergency
unblocking of the door lock. The emergency door opening has
been described as follows:
WARNING
BEFORE THE EMERGENCY DOOR OPENING TURN
OFF THE MACHINE MAIN SWITCH! NEVER OPEN
THE DOOR WHILE DRUM IS STILL RUNNING! NEV-
ER OPEN THE DOOR IF “TOO HOT” IS INDICATED!
RISK OF BURN OR SCALD INJURIES! NEVER OPEN
THE DOOR IF THE MACHINE PARTS FEELS TOO
WARM! NEVER OPEN THE DOOR, UNTIL THERE IS
NO WATER IN THE DRUM! IN THE OPPOSITE CASE,
IT WILL FLOW OUT AFTER OPENING THE DOOR.
C220
1. Before the door is open, check the washing water temperature
and machine parts temperature.
2. After machine cooling down insert suitable device (wire,
into the left hole (
) under washer
door and remove locking pawl to the left.
3. The door lock is unblocked. You can open the door.
UNBLOCKING OF THE DOOR LOCK IN CASE OF
EMERGENCY
Figure 34
ERROR INDICATION SHOWN ON DIS-
PLAY
See Chapter "
FIRST SERVICE AT TECHNICAL PROBLEM
Refer to the Programming manual, Chapter “
TROUBLE SHOOTING AIDS
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
60
Part No. D1612ENR3
