Alliance Laundry Systems LMA260_MICRO, Оригинальное руководство пользователя

Страница: 35 / 62

water and/or weather. Avoid damp conditions where water or
moisture could run down the walls and covers of the washer or
cover the floor around the washer. Do not install the washer
above an open gutter. Close any nearby gutters so that waste wa-
ter steam cannot collect near/inside the washer.
SIZE OF A LAUNDRY ROOM
IGNORING THE REQUIREMENT FOR SPACES BE-
TWEEN MACHINES AND WALLS CAN MAKE SERVICE
AND MAINTENANCE WORK DIFFICULT.
Total space requirements for the system installation are usually
determinate by a detailed plan of the building. The machine di-
mensions are stated in the Chapter “
TECHNICAL SPECIFICA-
TION ”. For replacement of service panel and maintenance of the
machine leave at least a 0.6 m / 23.62" free space between the left
panel of the machine and the wall and at least a 0.8m / 31.49"
free space between the right panel of the machine and the wall or
between the machines,
Figure 8 . The waste piping or outlet
channel must be dimensioned to the discharged water quantity
and a number of washing machines.
MACHINE POSITIONING
CARRYING CAPACITY OF THE FLOOR
WARNING
IT IS RECOMMENDED TO CONSULT STATIC RE-
QUIREMENTS WITH A STATIC ENGINEER TO MEET
THE REQUIREMENTS OF PERMISSIBLE LOADING,
VIBRATIONS AND NOISE LEVEL IN THE BUILDING!
C194
FASTENING THE MACHINE
VERSION WITH WEIGHING SYSTEM: see addition to Instal-
lation, maintenance and user's manual, part number D1603.
WARNING
THE MACHINE MUST ALWAYS BE FIXED TIGHTLY
TO THE FLOOR AND MUST FIT RELIABLY TO THE
FLOOR IN ALL FOUR SPOTS INTENDED FOR FIXING
THE MACHINE!
C195
In the floor consider only positioning of mechanical anchors for
fixing the machine and the suitable drain duct for the waste water.
Drill 4 holes into the floor in the spots according to installation
plan and the machine model, see
Figure 8 . Dimensions of holes
are given in the Table 4 . Remove lower covers from the machine
( Figure 5 , Figure 6 ) and install the machine in such a position,
so that the holes in the machine lower frame correspond correctly
with the holes drilled in the floor. Using a water level, check the
position of the machine base frame which must be laid horizon-
tally. The machine is fixed using the anchors,
Figure 8 . Put the
slightly assembled anchor (including screw) into the hole and
push it gently through profile of the machine lower frame down
to the level of washer. Tighten an anchor using a torque given in
the
Table 4 . The machine must be leveled and firmly fastened to
the floor which meets static and dynamic load of the machine.
The manufacturer is not responsible for incorrect installation re-
sults.
Installation plan (dimensions are stated in mm)
STANDARD
VERSION WITH
WEIGHING SYSTEM
HOLE DIAME-
TER 24 mm / 0.94" 16 mm / 0.63"
HOLE DEPTH 125 mm / 4.92" 60 mm / 2.36"
ANCHOR AE·B 24x210
M16/100 -
ANCHOR PAD - 4pcs, Ø98
TIGHTENING
MOMENT 100 Nm / 36
lbf.ft -
Table 4
INSTALLATION
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
35 Part No. D1612ENR3