
801774
93
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
58. ELECTRONIC COIN DROP
NOTE: Electronic Coin Drop is only available for
certain coin models (“A” or “X” in fourth position
[i.e. STEX17]).
a. Removal:
(1) Unlock control panel. Refer to
Step 1
.
(2) Pull top of control panel away from control
cabinet far enough to allow lifting control
panel up and off the rail support of the
control cabinet front. Refer to
Step 2
.
(3) Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 9, Step 3
.
(4) Reach into control cabinet to feel position
of coin drop.
(5) Disconnect wire harnesses from coin drop.
(6) Using CK096 Mounting Tool Kit, slide
mounting tool over guide wire and insert
guide wire into hole in mounting tool
(located on notched end of mounting tool).
.
NOTE: It is necessary to first slide opposite end of
mounting tool through clearance holes in divider
for easy access to guide wires. Refer to
.
(7) Loosen nut attaching coin drop to guide
wire. Use mounting tool handle for
increased leverage. Refer to
(8) Remove nut.
(9) Repeat for other nut.
(10) Slide coin drop off guide wires and remove
from washer.
b. Installation:
(1) Place coin drop into the control cabinet,
align holes with guide wires, and slide into
position.
(2) Position the coin drop all the way to the
front.
(3) Place one nut, smooth end first, onto a
guide wire and slide to front of coin drop.
Slide mounting tool (from kit CK096) over
guide wire and insert guide wire into hole in
mounting tool (located on notched end of
mounting tool).
NOTE: It is necessary to first slide opposite end of
mounting tool through clearance holes in divider
for easy access to guide wires. Refer to
.
(4) Tighten nut with mounting tool, using
mounting tool handle for increased
leverage.
(5) Repeat for other nut.
(6) Check guide wire on right side for
interference with coin return. If
interference is found, the rod may need to
be adjusted away from the drop.
(7) Reconnect wire harnesses to coin drop.
(8) Reinstall control panel in control cabinet
and lock control panel.
Содержание HTEB17-N2802
