
114
801774
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect all electric power to the machine and accessories before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start machine with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded.
• Washer motor not grounded! Disconnect electric power before servicing motor.
W502
WARNING
72. WASHER DOOR SWITCH
a. Open loading door.
b. Carefully remove wire clamp ring from groove
with small flat screwdriver. Spring is located in
the 6 o’clock position. Refer to
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to right or left of spring.
c. Grasp loading door seal lip. Refer to
Step 1
.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
d. Using a circular motion, pull seal up
Step 1
), out (
Step 2
), and
down (
Step 3
).
e. When seal releases from lip of front panel, pull
out and remove the seal from front panel around
Step 4
.
f. Reach up between door seal and front panel.
. Press in on switch locking
tabs and push switch out through front panel
only far enough to allow removal of wires from
switch terminals.
IMPORTANT: Refer to wiring diagram when
rewiring switch.
73. WASHER DOOR LATCH SWITCH
a. Open loading door.
b. Carefully remove wire clamp ring from groove
with small flat blade screwdriver. Spring is
located in the 6 o’clock position. Refer to
.
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to right or left of spring.
c. Grasp loading door seal lip. Refer to
Step 1
.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
d. Using a circular motion, pull seal up
(
Step 1
), out (
Step 2
), and
down (
Step 3
).
e. When seal releases from lip of front panel, pull
out and remove the seal from front panel around
door opening. Refer to
Step 4
.
f. While supporting door lock from behind
(through door opening), remove two Phillips
head screws holding door latch switch to front
g. Gently pull door lock out through door opening.
Remove door lock only far enough to
disconnect harness connector from door lock.
NOTE: When installing new door lock, be sure to
install small lip through mounting hole first and
then rotate lock into position.
Содержание HTEB17-N2802
