allen AMM12H13, Руководство по эксплуатации и запасным частям

Страница: 15 / 56

068238 Page 15
Assembly Instructions
1. Remove the mixer and all components from its shipping crate. You will see:
• Two (2) rim and tire assemblies.
• Axle assembly with hubs on each side, idler spring, and eight (8) lug nuts.
• Selected hitch with lock pin and bolt and safety bolt with hair pin.
Note: All installation hardware must be inserted into its respective location on the
mixer, see Section 4 for more details.
1. After removing all mixers’ safety packing, while standing on an end, locate the axle’s place on the mixer. You need to
locate the bolts attached to the mixer shroud, bolted to the pallet and make sure this bolts are removed.
2. Lift the axle up to the mixer frame and position it with the bracket spring lined up to the idler clutch hole on the mix-
er’s frame.
3. Insert two 1/2 inch bolts with a washer through the frame and the vertical mounting bracket on the axle. Secure each
bolt with a washer and locknut. Tight the bolts at 57 ft.-lbs.
4. Remove the lug nuts from the axle and mount the speed wheel, after wheel is mounted proceed to place the lug nuts
(make sure the conical (tapered) end is facing the inside of the wheel. Torque to 105 ft.-lbs.
5. Proceed with the second wheel using the steps of point #3.
6. Hook one end of the spring to the idler arm. Hook the other end of the spring to the spring plate on the axle. The
spring should be hooked through the second hole from the top toward the middle of the mixer.
7. Using appropriated Equipment, put the mixer down to the ground.
Warning: failure to use proper lifting equipment could cause mixer to fall and cause
serious injury.
1. Position the safety chain through the key slots in the front leg. Adjust the chain’s ends to equal length.
2. Remove the safety bolt and pin from the tow bar.
3. Install the tow bar through the front leg.
4. Insert the pin through the front leg and the front hole in the tow bar. Secure the pin with a hairpin cotter.
5. Insert the 3/4” bolt through the rear hole and secure with a lock washer and nut. Tighten securely.