5
Assembly
IMPORTANT
! Before assembly and each use, inspect this product for damaged
hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are
missing or broken. Contact your retailer for replacement parts and instructions if
needed. Never substitute parts.
•
Remove the trailer hitch arm by removing QR pin (#1) and press the spring (#2)
(and pull the arm out.
•
Assemble on side of the front fork cross brace (#3) as shown above, using 2
socket head screws (#4) provided – at this point, just snug the screws, do not
tighten completely
•
Insert the jogger arm you have just assembled into one of the aluminum hitch
arm brackets (#5) on the frame, sliding in until the spring pin (#3) locks in place.
•
Take the other arm, and insert in the bracket on the opposite side of the frame,
sliding in until the spring pin locks in place.
•
Insert remaining 2 screws in holes provided in the fork leg (#7), and tighten
loosely in the support bracket.
•
Install wheel in slots in plastic fork ends, aligning the axle which has a flat side to
match the slot in the fork end.(#8)
•
Once wheel is in place and Quick release lever (#9) locked in place, tighten the 4
screws to secure the front fork assembly (#10).
3. Photo of inspecting
installation by pulling
out on wheel
#1
#2
#3
#4
#5
#7
#8
#9
#10
