Allen-Bradley VersaView 1200M, Руководство пользователя

Страница: 19 / 62

Publication 6186M-UM001D-EN-P
Installation 2-9
5. Install the mounting clips. The mounting clips slide into the slots
on the top, side and bottom of the monitor.
6. Gradually tighten the clips one at a time around the bezel using
the specified sequence. Note that the sequence begins with the
center clips and continues to the corner clips.
Repeat this process at least three times until the clips are
hand-tight and the gasket is compressed uniformly against the
panel.
7. Tighten mounting clips to a torque of 10 in-lbs (1.1 N•m) in the
sequence shown in step 6. Do not over-tighten.
Mounting Clips for VersaView 1500M /1700M
(The number of mounting clips varies by model)
Torque
Sequence
Torque
Sequence
8
1 5 7
2 6
4 3
7 1 5
6 2 8
9 3
4 10
VersaView 1500M and 1700M VersaView 1200M
Torque
Sequence
14 1 5
13
4
VersaView 2000M
6
11 10 2 9
12
7
3
8
ATTENTION
Tighten mounting clips to a torque of 10 in-lbs (1.1
N•m) to provide a proper seal and prevent damage
to the monitor. Rockwell Automation assumes no
responsibility for water or chemical damage to the
monitor or other equipment within the enclosure
because of improper installation.
Allen-Bradley Spares