Allen-Bradley SLC 500 1747-L511, Инструкция по установке и эксплуатации

Страница: 7 / 28

6–10 Installing Your Hardware Components
Publication 1747-6.2
Two cables are available to link modular hardware chassis. Catalog
Number 1746-C7 cable is 152.4 mm (6 in.) in length and used when
connecting chassis side-by-side. Catalog Number 1746-C9 is
914.4 mm (36 in.) in length and used to link one chassis below the
other.
!
ATTENTION: Do not use any other cables than those
provided. Longer cables could affect the integrity of
data communications between the chassis, possibly
causing unsafe operation. Also, make sure the cable is
properly secured to protect against the effects of shock
and vibration.
Install the chassis interconnect cable before installing the power
supply in multiple chassis configurations.
The cables are “keyed” for proper installation. The end of the cable
that plugs into the right socket in the chassis has the “key” on the top
of the connector. The opposite end of the cable has the “key” on the
inside of the connector for insertion into the expansion chassis.
To remove the cable, move the tabs on the socket outward and the
connector pops out.
!
ATTENTION: The expansion cable must always exit
the right end of the chassis with the processor. Refer to
the following figures.
C
P
U
Chassis 1
Chassis 2
CORRECT INSTALLATION
C
P
U
Chassis 1
Chassis 2
INCORRECT INSTALLATION
C
P
U
Chassis 1
Chassis 2
INCORRECT INSTALLATION
Chassis 1
Chassis 2
INCORRECT INSTALLATION
P
S
P
S
P
S P
S
P
S P
S
P
S
P
S
C
P
U
Installing Your Chassis
Interconnect Cable