Allen-Bradley SLC 500 1747-L511, Инструкция по установке и эксплуатации

Страница: 17 / 28

10–9 Troubleshooting
Publication 1747-6.2
Identifying SLC 5/02 Processor Communication Errors
The Following
Error Exists
Probable Cause Recommended Action
The SLC 5/02
processor is not
receiving data.
DH-485
communication
parameters are
improperly set up.
1. Check communication parameters of programmer.
Programmer and processor baud rate must match.
Programmer and processor node addresses must be
different.
2. Try different combinations of:
a. baud rate (Processor default is 19200.)
b. node address (Processor default is 1.)
3. Try to increase the maximum node address. (Default
is 31.)
receiving data.
No
communication
to the
programmer.
Bad Connection of
Communication
Device
1. Check cable continuity.
2. Check cable connections between programmer and
processor.
3. Check communication device (for example, the
1747-PIC). Replace if necessary.
Low or No Power
to Communication
Device
1. Verify proper power supply selection and backplane
loading. (1747-PIC and 1747-AIC draw power off the
backplane.)
2. Verify proper 120/240V power supply jumper selection.
See page 6–8.
Refer to the following key to determine the status of
the LED indicators:
Indicates the LED is OFF.
Indicates the LED is ON.
➀
The RUN LED on the SLC 5/01 processor is
actually labeled “PC RUN.” Also, the
SLC 5/01 processor does not have a COMM
LED.
Indicates the LED is FLASHING.
Status of LED does not matter.
ÉÉ
ÉÉ
Indicates the LED is FLASHING or OFF.
POWER RUN
CPU FAULT
FORCED I/O
BATTERY LOW
ÉÉ
ÉÉ
COMM
If the LEDs indicate:
➀