14
Industrial Computers for Hazardous Locations
Rockwell Automation Publication 6181X-IN001C-EN-P - April 2011
4.
Slide the mounting clips into the holes on the top, bottom, and sides of the computer.
5.
Gradually tighten the clips, one at a time, around the bezel by using the specified
sequence starting with the center clips and continuing to the corner clips.
6.
Tighten the mounting clips to a torque of 1.4 N•m (12 lb•in) by using the sequence in
, being sure not to overtighten.
Repeat this process at least three times until the clips are properly torqued, making sure
the gasket is compressed uniformly against the panel.
ATTENTION:
Tighten the mounting clips to the specified torque to provide a
proper seal and prevent damage to the product. Rockwell Automation assumes
no responsibility for water or chemical damage to the product or other
equipment within the enclosure because of improper installation.
1
10
9
2
7
8
5
4
3
6
