28
Rockwell Automation Publication 2715-UM001A-EN-P - July 2015
Chapter 2
Install the PanelView 5500 Terminal
Mount the Terminal in a
Panel
The PanelView 5500 terminals were designed for single-person installation. No
tools are required except for the tools needed to make the panel cutout.
Follows these steps to mount the terminal in a panel.
1.
Use the cutout dimensions on
to cut an opening in the panel.
2.
Verify that the sealing gasket is present on the terminal.
This gasket forms a compression type seal. Do not use sealing compounds.
3.
Insert and stabilize the terminal in the panel cutout.
a. Insert levers in the top corner slots in the orientation shown in
and rotate the non-flat side of the levers toward panel.
b. Tilt the terminal toward the panel cutout and guide upward into the
cutout. Make sure that the levers stay intact.
ATTENTION:
Disconnect all electrical power from the panel before making the panel cutout.
Make sure that the area around the panel cutout is clear and that the panel is clean
of any debris, oil, or other chemicals.
Make sure that metal cuttings do not enter any components that are already
installed in the panel and that the edges of the cutout have no burrs or sharp
edges.
Failure to follow these warnings can result in personal injury or damage to panel
components.
TIP
The mounting levers for PanelView 5500 terminals are black (catalog
number 2711P-RMCP).
Do not use gray mounting levers; they are not compatible with
PanelView 5500 terminals.
Gasket
Flat side
TIP
The levers prevent the terminal from falling out of the panel.
Содержание 2715-15CA
