Communication Interface Module
Cat. No. 1784-KT2/C
Installation Data
16
2.
When the prompt appears, type the following to select the hard disk:
c: [ENTER]
3.
When the prompt appears, type the following to select the top
directory of the hard disk:
cd c:\ [ENTER]
4.
When the prompt appears, type the following to create a directory
called KT:
mkdir kt [ENTER)
5.
When the prompt appears, type the following to create a directory
called KT2DIAG:
mkdir kt2diag [ENTER]
6.
When the prompt appears, insert the backup copy of the Options and
Diagnostics diskette into drive A:.
7.
Type the following to copy the Z80 diagnostic files to the KT
directory:
copy a:\kt\*.* c:\kt [ENTER]
8.
When the prompt appears, type the following to copy the diagnostic
program files to the KT2 directory:
copy a:\*.* c:\kt2diag [ENTER]
The diagnostic program now resides in the C:\KT2DIAG directory, and the
files the diagnostic program depends on now reside in the C:\KT directory.
Starting up the Diagnostic Program
Read the following checklist to help avoid damage to your network before
starting up the diagnostic program:
Make sure your network or PLC is not connected to a 1784–KT2 while
the diagnostic program is running.
Make sure other programs are not running at the same time the
diagnostic program is running.
Do not run the diagnostic program in a windowing or multi–tasking
environment. The diagnostic program does not support these
environments.
Make sure there are no terminate–stay–resident (TSR) software
programs loaded in your PS/2 before you run the diagnostic program.