Rockwell Automation Publication 1783-IN016B-EN-P - March 2019
17
Stratix 5700 Ethernet Managed Switches
Connect to PoE Ports
Switches with PoE ports require a separate power supply. For power input requirements based on your application, refer to
page 13
.
1.
Insert a straight-through, twisted four-pair, Category 5e or better cable with an RJ45 connector into the PoE port.
2.
Insert the other cable end into an RJ45 connector on the other PoE powered device.
Connect to SFP Module Ports
To connect a fiber-optic cable to an SFP module, follow these steps.
1.
Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.
2.
Insert one end of the fiber-optic cable into the SFP module port.
3.
Insert the other cable end into a fiber-optic receptacle on a target device.
4.
Observe the port status indicator:
• The status indicator turns amber while the SFP discovers the network topology and searches for loops. This process takes about 30
seconds, and then the port status indicator turns green.
• The status indicator turns green when the switch and the target device have an established link.
• The status indicator turns off if the target device is not turned on or there is a problem with the cable or the adapter that is installed in
the target device.
If necessary, reconfigure and restart the switch or the target device.
PoE In
put Pwr
48VDC, 1.2A
