54
Rockwell Automation Publication IASIMP-QS023B-EN-P - December 2012
Chapter 4
Configure the DeviceNet Network
•
The tasks described in Chapter 2,
Prepare the Computer and Load Controller Firmware
on
, including:
–
Install the Studio 5000 environment and RSLinx Classic software
Logix Designer application is installed when you install the Studio 5000 environment.
–
Configure an EtherNet/IP driver in RSLinx Classic software
–
Set the IP address for the computer
–
Load firmware on the controller
•
Verify that power is applied to all devices
What You Need
lists the components you use in this chapter.
Table 7 - What You Need to Configure the DeviceNet Network
Component
Description
RSNetWorx for DeviceNet software
Configuration software that creates a scanlist of devices that exchange information with the
controller over a DeviceNet network.
DeviceNet power components
Components necessary to power the DeviceNet network.
This example uses the 1606-XLDNET8 and a KwikLink power tap module.
IMPORTANT
: Make sure that you include termination resistors in the DeviceNet
network installation.
