Rockwell Automation Publication 1756-IN061B-EN-P - February 2017
9
Armor ControlLogix Controllers
Make Power Connections
The bottom of the enclosure has two sealed mini-style power connectors that operate in parallel with one another to allow daisy-chaining of device
power with other devices. The unit receives its required power through the male connector. The female connector lets power be daisy-chained to
another ArmorStart®, Armor ControlLogix, Armor GuardLogix® or On-Machine™ I/O products.
1. Remove the dust cap from the female power connector on the bottom of the enclosure.
2. Make power connections and tighten to hand tight plus one half-turn.
IMPORTANT
Use the 1585D–M4DC–H: Polyamide small body unshielded or the 1585D–M4DC–SH: Zinc die-cast large body shielded mating connectors for the D-Code
M12 female network connector.
IMPORTANT
Use two twisted-pair CAT5E UTP or STP cables.
ATTENTION:
When you use a shielded Ethernet cable, this product terminates the shield-to-chassis ground through the Ethernet connector bulkheads.
If another component that ties its Ethernet connector bulkhead to ground is connected to this product with a shielded Ethernet cable, a ground loop is created.
When you use shielded Ethernet cable, follow the guidelines for use of shielded cable, most importantly the guidelines for eliminating ground loops.
For information on eliminating ground loops, see the ‘ODVA EtherNet/IP Media Planning and Installation Manual’, available on the
ODVA website
.
For more information on how to select cables for EtherNet/IP Networks, see the Guidance for Selecting Cables for EtherNet/IP Networks White Paper,
publication
ENET-WP007
.
Male Connector (Power Input)
Female Connector (Power Output)
Pin
Signal
1
V+ Switched
2
V+ Unswitched
3
V- Unswitched Common
4
V- Switched Common
IMPORTANT
On Machine end devices, such as the Armor ControlLogix controller, use the EN-50044 wiring standard while On-Machine cordsets with flying leads use the
SAE-J-1738A standard for wiring. Use care to follow the pin numbering convention that is shown below before powering up the unit.
IMPORTANT
If you disconnect power connections from these ports, reattach the dust cap and finger-tighten.
D-Code M12 Pin
Wire Color
Signal
8-way Modular RJ45 Pin
1
White-Orange
TX+
1
2
White-Green
RX+
3
3
Orange
TX-
2
4
Green
RX-
6
Cordsets with Flying Leads (per SAE-J-1738A)
Armor ControlLogix Controller (per EN 50044)
Female
Female
Male
Male
1-Black [V-] 2-White [E-] 3-Red [V+] 4-Green [E+]
1-Red [V+] 2-Green [E+] 3- White [E-] 4-Black [V-]
