- 32 -
CISA MYEVO RFID READER
CONSTRUCTION MODE
Thismodeallowsdoormanufacturerstotestthedoorandinstallerstofititeasieronsite.
When a MyEVO lock and its accessories (keypad/RFID) are purchased, it is in
CONSTRUCTION MODE
. In this mode it is possible to:
• Open the door by entering the factory set
Master Code
, 12345678
• Open the door by holding the
Master Card
up to the RFID reader
• Open the door by holding any
User Card
up to the RFID reader
To exit
CONSTRUCTION MODE,
do one of the following:
•
Create a new Master Code
for the keypad (only the new Master Code will open the lock)
•
Create a new User Code
for the keypad (only the new User Code will open the lock)
•
Associate the RFID reader
with the MyEVO lock (only the Master Card will open the lock).
MASTER CARD
The
Master Card
is a single card which is supplied with the CISA MyEVO RFID reader and
must be kept very safe by the door administrator.
The
Master Card
has the following functions:
• If the door is locked and the lock is in construction mode, the
Master Card
opens the door
• If the door is locked and the lock is not in construction mode, the
Master Card
does not
open the door
• If the door is open and the RFID reader has not yet been associated with the lock, the
Master Card
associates the RFID reader with the lock.
• If the door is open and the RFID reader has been associated with the lock, the
Master
Card
activates the programming mode.
Please keep the
Master Card
in a safe place.
ASSOCIATING THE CISA MYEVO RFID READER WITH THE LOCK
This must be done with the DOOR OPEN.
1. Hold the
Master Card
up to the RFID reader
5
5
5
The CISA MyEVO RFID reader is now associated with the lock.
ENABLING A USER CARD OR A MINI USER CARD
This must be done with the DOOR OPEN.
1. Hold the
Master Card
up to the RFID reader
2. Hold the card or the mini card to enable up to the RFID reader
Everytimeacardoraminicardisheldup,thegreenLEDwillflashtoconfirmithasbeen
enabled. Up to 100 cards or mini cards can be enabled. After 10 seconds of inactivity, the yellow
LED goes off and programming mode is exited.
