www.allavino.com
7
1-888-980-4809
Racking Configuration
Disperse your bottles evenly throughout the unit so as not to concentrate weight in any one area. This also helps to
provide an even temperature range throughout the unit. Make sure that bottles are not all grouped together either at
the top or bottom of the cabinet. The maximum capacity per shelf is 55 lbs. Never try to pull out more than one rolling
shelf at a time as it can cause the appliance to tip forward. Also, be careful that your bottles do not touch either the back
of the cabinet or the step at the bottom because contact with these cold surfaces can cause ice to form in the bottle.
The Allavino Wine Cellar has wood presentation shelves that glide smoothly on ball-bearing tracks which allow easy
access to your entire collection. It has 8 sliding shelves that will hold up to 11 standard 750ml wine bottles each, and a
stationary bottom rack that can hold 6 bottles, or can be removed to allow you to store up to 11 bottles in the bottom
area. The overall bottle capacity will vary depending upon the size of your bottles.
You can remove a shelf to accommodate larger diameter bottles on the shelf below it. To remove a shelf, pull it out as
far as you can. There are levers on each side of the shelf near the rollers. Left the lever on the left hand side and push
down the lever on the right hand side to remove the shelf from the tracks.
Installation of Door Handle
The Stainless Steel version of this model has optional curved or towel bar handles. The screws are already installed in
the door, so complete these easy steps to attach the handle to the door.
1.
Pull back the door gasket from behind the handle screws.
2.
Align the male threaded end of the top screw with the female thread of the door handle.
3.
Using a Philips screwdriver, thread the top screw into the upper part of the handle first.
4.
Then align the bottom screw with the lower part of the handle and tighten it into place.
5.
Tighten both screws until snug. Do not over tighten.
Note: On some models, the screws for the curved handle are slightly smaller than the screws installed in the door.
Remove existing screws by tapping the end of the screw through the hole from the outside of the door. If there is some
resistance, gently tap the end of the screw with the handle of the screwdriver until screw is all the way out.
This wine cellar has 8 sliding shelves that can hold up to 11
bottles each, and either 6 bottles on the stationary bottom
rack, or 11 bottles in the bottom area with the rack
removed. It has a maximum capacity of 99 bottles, based
on the standard Bordeaux size bottle. Your total bottle
capacity may vary depending upon the size of the bottles
in your collection; larger bottles will decrease the capacity.