13. LIGHT KIT
Our Light kit is designed specifically for use on
this
Generator.
Tools required: Phillips Screwdriver
Fittings supplied:
(1) Portable Digital Generator
(2) Light Kit Assembly
(3) Antiskid Round Nut
(4)
Antiskid Round Stud
(5) Left Mount Plate of Light Kit
(6) Right Mount Plate of Light Kit
(7) Screw M5
45 2PCS
(8) Screw M5
16 1PCS
This is where the Light Kit will be mounted, see Assembly Drawing of th
e Portable
Digital Generator Light Kit.
(1) Remove the screw from the Portable Digital Generator and the screws from
the side
of the control plate;
(2) Disperse the mount plate of the Light, Use screw M5
45 and screw M5
16, then locate
the mount plate of Light Kit on generator. DO NOT TIGHTEN SCREWS.
(3) Use the antiskid round stud through the Ligh
t
left and right mount plate in turn, then lock
the antiskid round stud.
(4) After adjusting the turnover angular of Light, tighten the above mentioned of antiskid round
stud, screw M5
45 and screw M5
16 in turn.
Before energizing the light, be sure to read the Generator Owner's Manual for best operation
and maintenance information, along with the safety precautions. It is recommended that the
light switch be in the OFF position when starting the generator.
MOUNTING INSTRUCTIONS FOR
LIGHT KIT
-
-
M5
45
M5
45
M5
16
