Alinco DX-10, Инструкция по эксплуатации

Страница: 20 / 44

10 10
10
This menu is to select frequency of Roger Beep. The frequency range
is 300Hz—3KHz. The shift step is 10Hz.
Default:
1050Hz
(10) RBT (ROGER BEEP Holding Time)
This menu is to select Roger Beep Holding Time from 50ms - 1000ms.
The shift step is 50ms.
Default: 500ms
(7) TDC (Power Supplied Voltage Protection)
This menu is to choose whether to enable Power supplied Voltage
Protection function or not.
ON:
When ON is selected, the radio will detect the supplied voltage.
Once the voltage surpasses the voltage setup in advance, the
radio would display “DC LO” or “DC HI” to remind you that the
voltage is not in normal state. Meanwhile, the radio will prohibit
transmitting and emit beep prompt.
OFF:
When OFF is selected, the Power Supplying Voltage is disabled.
Default: ON (DC 10.5V-16V)
(8) TLD (Content displayed on the LCD when transmitting)
This menu is to set the content displayed on the LCD when
transmitting.
(9) RBF (ROGER BEEP Frequency Setting)
ON:
When ON is selected, the radio will detect the SWR of antenna.
Once the SWR is beyond the SWR set in advance, the radio
would prohibit transmitting automatically and loudspeaker will
emit voice prompt. Then, “HI S” icon will display on the LCD to
remind you that the antenna SWR is too high or antenna do not
connect well.
OFF:
When OFF is selected, SWR Protection function is disabled.
NOTE:
To protect the radio from long transmission under high SWR,
the radio would automatically start SWR Protection once the
SWR Value is higher than 20:1.
Default:
ON (SWR=<10:1)
TF:
When TF is selected, LCD would display transmitting
frequency when transmitting.
SR:
When SR is selected, LCD would display SWR value of antenna
when transmitting, for example: "1.2" on the LCD.
BAT:
When BAT is selected, LCD would display Supplied Voltage
when transmitting, for example: "13.8DC" on the LCD.
TOT:
When TOT is selected, LCD would display TOT remaining time
when transmitting. And TOT would count down till remaining time
is 0, for example: "170" displayed on the LCD display.
Default:
TF
TI: When TI is selected, scan would stop when a valid signal is
detected. The radio would resume scanning 5 seconds later,
whether signal disappears or not.
Default:
SQ
This menu is to choose whether to enable Transmitting SWR
Protection function or not.
(6) TSR (Transmitting SWR Protection)