11
11
11
(14) CSV
This menu is to adjust the side voice of CW SIDE VOL CW. 64 grades
in total. Default: 31.
(16) BEU
This menu is to set the volume of beep. 64 grades in total(OFF,0-63).
Default: 31
OPERATING PROCEDURE TO RECEIVE
(12) TON (Transmitting Single-Tone Frequency)
This menu is to select Transmitting Single-
Tone Frequency from 300Hz -3kHz. The
shift step is 10Hz.
Default:
1050Hz
(13) NOG
It refers to TX MON function. Users can set the volume and grade of
the TX MON by software. The higher grade goes to louder TX MON.
64 grades in total (OFF,0-63)
Default: OFF
Be sure that power supply, microphone and antenna are
1.
connected to the proper connectors before going to the next
step.
Turn the radio on by tuning VOLUME control clockwise.
2.
Rotate the VOLUME knob to set a comfortable listening level.
3.
SET the MODE knob to the desired mode.
4.
Set the CHANNEL selector knob to select the desired channel.
5.
Set the RF gain control full clockwise to maximum RF gain.
6.
Listen to the background noise from the speaker. Turn the
7.
SQUELCH control clockwise slowly until the noise disappears (no
signal should be present). Leave the control at this setting. The
Squelch is now properly adjusted. The receiver will remain quiet
until a signal is actually received. Do not advance the control too
far, or some of the weaker signals can not be heard.
OPERATING PROCEDURE TO TRANSMIT
Select the desired channel of transmission.
Press the PTT key on the microphone and speak in a normal voice.
1.
2.
(15) ICG
This menu refers to MIC GAIN function.
Users can set the value by software. The
higher value goes to higher sensitivity. 64
grades in total (OFF,0-63).
Default: 5
(11) CFR (CW Side Tone Frequency)
This menu is to select CW Side Tone Frequency from 300Hz-3kHz ,
the shift step is 10Hz.
Default:
1050Hz.
