Align Trex Se Setup Guide
System Mode.
❍
Press scroll until TYP is displayed.
❍
Press increase and select HE.
❍
Press scroll until GER is displayed.
❍
Press increase and select A
❍
To save either turn the radio off or press scroll and increase at the same time.
●
Now we will set options in Function Mode.
❍
Turn the radio on if it is not already on.
❍
Press scroll and increase. You are now in function mode.
❍
The servo reversing menu (REV.NORM) should be visible. If not press scroll until it is.
❍
Once you reach the reversing menu, use the channel key to scroll through each channel and set
them to the following.
■
AIL=REV
■
ELE=NORM
■
RUD=NORM
■
GER=NORM
■
PIT=NORM
■
THR=NORM
❍
Press scroll until TRV ADJ. is visible.
❍
Press scroll and select the GER channel.
❍
Place the Aileron DR switch to 0. Use the decrease button to set +45%.
❍
Press scroll until HLD is visible.
❍
Use decrease and set to -1%.
❍
Press scroll until you reach the Pitch Curve Menu. Use the channel button to select PLN, P2N and
PHN and set the following values using increase and decrease.
■
PLN=35%
■
P2N=50%
■
PHN=100%
❍
Press scroll to advance to the next Pitch Curve Menu. Use the channel button select PLS, P2S and
PHS and set the following values using increase and decrease.
■
PLS=0%
■
P2S=50%
■
PHS=100%
❍
Press scroll to advance to the next Pitch Curve Menu. Use the channel button select PLH, P2H and
PHH and set the following values using increase and decrease.
■
PLH=0%
■
P2H=50%
■
PHH=100%
❍
Press scroll to advance to the Throttle Curve Menu. Use the channel button select TLN, T2N and
THN and set the following values using increase and decrease.
■
TLN=0%
■
T2N=65%
■
THN=100%
❍
Press scroll to advance to the Throttel Curve Menu. Use the channel button select TLS, T2S and
THS and set the following values using increase and decrease.
■
TLS=100%
■
T2S=80%
■
THS=100%
❍
Press scroll until your reach the CCPM Menu. "mix CCP OF" is displayed.
❍
Press increase to enable CCPM. Display will change from CCP OF to CP2.
❍
Use the channel button to select CP2, CP3 and CP6. All three should have a value of 60% by
default. Use increase and decrease to set the following values.
■
CP2 = 30% (Approximately 6 degrees of total cyclic travel [ -, + 3 degrees left and right] )
■
CP3 = 30% (Approximately 6 degrees of total cyclic travel [ -, + 3 degrees forward and aft] )
■
CP6 = 60%
■
CP2 and CP3 adjusts the cyclic travel of your swashplate (forward, back, left, right)
■
CP6 adjust the total up and down travel of the swashplate (pitch of rotor blades)
http://www.digimemphoto.com/pdf/ (2 of 13)1/25/2006 7:09:05 PM
