Align Trex Se Setup Guide
■
CP2 and CP3 can be increased if you are experienced or after you become
comfortable with your heli. The transmitters default setting of 60% will give
you about 12 degrees total cyclic travel, [ -, + 6 degrees]. At this high setting
the mechanics are very near binding. In addition using that much cyclic may
cause bogging. Shoot for 6 degrees total and then advance to around 9
degrees total.
The radio settings should now be very close to final with the exception of possible servo reversing, subtrims and gyro
gain adjustments.
#2 Servo mounting, connections, direction and centering
Servo mounting may vary slightly but I found the following offers good alignment. Servo connections shown are for
the DX6.
Figure A
Note Ch. 6 servo is mounted from the inside and Ch. 3 is mounted from the outside of the left frame with the servo
horn inside the frame halves.
Figure B
http://www.digimemphoto.com/pdf/ (3 of 13)1/25/2006 7:09:05 PM
