NOTE: If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place before
replacing the speakers.
Steps
1. Using the alignment posts, place the left and right speakers into their slots on the palm-rest and keyboard assembly.
2. Replace the four screws (M1.6x1.8) that secure the left speaker and right speaker to the palm-rest and keyboard assembly.
3. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
4. Adhere the tape that secures the speaker cable to the areas etched "S" for speaker cable.
5. Connect the speaker cable to the system board.
6. Slide the keyboard-controller board cable into the connector on the system board and close the latch to secure the cable.
Next steps
1. Install the
.
2. Install the
3. Install the
.
4. Follow the procedure in
After working inside your computer
.
34
