User Manual for ST School Milk Cooler
Beverage-Air
Rev. 06/20
Beverage-Air
7
UNPACKING AND SET UP
Carefully inspect the shipping carton for damage. This is the only time that shipping damage may be claimed. If damage is
suspected, open the carton immediately and, if there is damage, retain the carton and contact the shipper to make a claim.
Do NOT contact the manufacturer.
Uncrating
Tools Needed: ¾” box wrench, adjustable wrench, level,
flat head screw driver, and box cutter.
1. First, remove the cardboard top capping, all clear
tape, and all staples including those at the bottom of
the cardboard carton and skid.
2. Next, start from the top of the carton. Using the box
cutter, carefully make one continuous cut to the
bottom of the skid. Remove cardboard carton and
discard.
3. Then, move unit as close to final position as possible
before removing the skid.
4. Move unit as close to final position as possible before
removing the skid.
Note: The skid must be removed before the casters or legs
can be attached.
Do NOT tip unit on its front or sides. If tipped onto the
back, unit must not be started for 3 hours.
Leveling:
Cabinet must be installed on a level surface. Failure to
install on a level surface may result in the door not sealing
or not remaining in position correctly, or during defrost
maintenance, condensed water not draining properly.
Install or attach any accessories that will be used
Remove any plastic covering the stainless steel.
CAUTION
Do NOT loosen casters to level
the cabinet. Casters MUST be
tightly secured to cabinet for
full strength.
