ALGE-Timing Timy3 WP, Руководство пользователя, Страница: 26 / 40

Manual
Timy3 - General
-26-
9.4 DISPLAY
This is for setting the Timy3 display and scoreboard.
9.4.1 RUNNING TENTH
In the display and via interface the running time is issued in 1/10. Function is not available for
all programs. Factory setting: OFF
9.4.2 DELAYTIME 1
The delay time determines for how long the intermediate times are shown on display and
scoreboard. The display time can be set e.g. for intermediate times of the running time in sec-
onds. Moreover, this time is also applied for the automatic start number continuation at the
finish. Factory default is
03 seconds.
9.4.3 DELAYTIME 2
This is for setting the display time for total time. Factory default is 03 seconds.
9.4.4 BACK LIGHT
This is to adjust the backlight of the display. Factory default is <ENERGY SAVE>.
9.4.4.1 ENERGY SAVE
Backlight is switched on during external power supply, switched off during battery supply.
9.4.4.2 ON
Backlight is always switched on.
9.4.4.3 AUTOMATIC
Backlight is switched on for 5 seconds with each keystroke and timing impulse.
9.5 INTERFACE
Settings for the RS232 and scoreboard interface. Some settings are only available in certain
programs.
9.5.1 DISPLAYBOARD
These are settings for
ALGE-TIMING
displays of the type D-LINE or GAZ.
•
< BRIGHTNESS > adjusts the brightness (0 – 9) of the LED display board
•
< TIME + DATE> internal time and date of scoreboard is synchronized
•
<DISPLAY MODE> without function
•
<BAUDRATE> standard is 2400, the baud rate of the Timy3 and also of
the scoreboard is set
•
<TIMEOUT> period after which the display switches to time of day
•
<ADRESS> address for LED display board
•
<SAFETY CAR> display mode permanent or flashing
•
<LAPS> number of laps
•
<CTD

LAP> manual or automatic
•
<FORMAT> output of time of day or match time
•
<BOAED ON OFF> OFF: no display board data output
ON + WTN OFF: display board data output via interface
(banana socket), but not via WTN (radio)
ON + WTN ON: display board data output via interface
(banana socket) and WTN (radio)
•
<STANDING TIMES> adjustment in program LapTimer between running time
(factory setting) and standing time (only stop times)