ALGE-Timing Timy SPEED, Руководство пользователя, Страница: 5 / 9

Timy SPEED
Page 5
2.2.2 Directions
You can chose between three settings:
Hint: For Speed 2 (C2-C3) and Speed 3 (C4-C5) both directions are accepted.

C0 < -- > C1 Measuring from both directions possible

C0 -- > C1 Measuring only of direction Start RLS (green cable or C0)

C1 -- > C0 Measuring only of direction Stop RLS (red cable or C1)
2.2.3 Unit
Here you can adjust the unity of the speed. This setting is valid for all measurement points.

km/h kilometres per hour

mph miles per hour

m/s meter per second

time
2.2.4 min. speed
In this program you can adjust the minimum speed for a valid measurement. This setting is
valid for all measurement points.
2.2.5 max. speed
In this program you can adjust the maximum speed for a valid measurement. This setting is
valid for all measurement points.
2.2.6 Horn Level
If the measured speed is higher than the adjusted value there is a horn signal on the option-
ally available horn speaker DL25.
To switch off this function you have to adjust the value to 0 km/h.
2.2.7 Meas-Points
The Timy can measure up to 3 different speeds with 6 photocells.
You have to adjust here the amount of measuring points you like to use.
All 3 Speeds are shown on 3 different display boards.
Main Speed:
C0-C1 Display Address 0
Speed 2: C2-C3 Display Address A
Speed 3: C4-C5 Display Address B
2.2.8 Print times
If it is adjusted to „OFF“, it will print only the startnumber and the speed.
If it is adjusted to „ON“, it will print additionally start- and finish-time as well as the run time.
2.2.9 Showing the top speed
Every time when it gives a new best top speed, it will be shown on the display board (ad-
dress 4) and the printer of the Timy.