Manual
ASC3
Page 7
1.2
Power Supply (12+14)
The power supply is integrated in the startclock. It has an input for 100-240V AC or 12 – 15
VDC. The start clock has an internal battery. If the startclock is connected to the mains sup-
ply, the battery charges.
Working Time:
approximately for 18 hours at 20°C or 5 hours at –20°C
Charging Time:
about 12 hours with empty battery
1.3
Display
1.3.1 Time of Day (F)
•
Figure height is 55 mm, separated by colons
•
The display shows hours, minutes, and sec-
onds (2 digits for seconds)
1.3.2 Start Number (Bib) (D)
•
Figure height is 80 mm
•
3 yellow LED numbers
•
3 digits to show the start number (bib)
1.3.3 Countdown Time (E)
•
Figure height is 80 mm
•
3 red LED numbers, separated by a colon
•
3 digits for countdown
1.4
Start Light (A, B and C)
The start light has a red, yellow, and green LED cluster. The
start light looks like a traffic light for the starter.
1.5
Horn (8 + 9)
The horn is used to release an acoustic signal of the count-
down. This acoustic countdown is normally in use during the final 5 seconds. If the count-
down takes longer than 10 seconds a warning tone can be released at 10 seconds. There
are two frequencies for the countdown. The lower frequency is for warnings and the higher
frequency for the start signal. You can adjust the volume of the horn with the lever (8). Alter-
natively, it is possible to connect an external horn at socket (9).
1.6
Mounting of the Startclock
The startclock has two possibilities for mounting:
•
3/8 inch screw for tripod in the center of bottom side
•
two straps to hang it on a wall
Содержание ASC3
Страница 1: ...Manual Version E140514 ...
Страница 39: ...Manual ASC3 Page 39 ...