ALGE-Timing ASC3, Руководство пользователя

Страница: 28 / 40

Manual
ASC3
Page 28
3 Parameter setting
To set the parameters you have two possibilities:
•
Parameter setting in the startclock
•
Parameter setting from a PC
3.1 Parameter Setting in the Startclock
To enter the parameter setting menu press yellow push button PB2 (2) for about 9 seconds
until the time of day display (F) shows <dISSTF>.
You can choose the parameters you want to change with the green push button PB1 (1).
Confirm with the yellow button PB2 (2). You can change the parameter with the green push
button PB1 (1). With the yellow button PB2 (2) the change is confirmed.
You can proceed to another parameter with green button PB1 (1). If no button is pressed for
the next 3 seconds you automatically exit the parameter mode.
dISStt ............. display start time of first competitor
PrInt ............... print memory
StOrE ............. select if you want to clear the memory
PrOGrA .......... select the program (from 00 to 99)
Cd# ................ countdown time #
LIGHt ............. start light adjustment
tOnE# ............ speaker tone (# = L for low tone or H for high tone)
SEtUP ............ to reset all parameters to standard (company setup)
01:00 gPS .... GPS offset of correction time
16 LEA .........
bib .................. show the ID-number (bib) on the display (on or off
3.1.1 Display the Start Times <dISStt>
The display (F) shows blinking <dISStt> ( Dis play St art T ime).
•
Press the green push button PB1 (1) and display (F) shows the start time of the previ-
ous competitor
•
On display (E) you see the lead/leg time.
•
If the start light is yellow, the start was after the zero impulse.
•
If the start light shows green, the start tolerance was okay.
•
If the start light shows red, the start was outside the start tolerance
•
If you press the green button PB1 (1) the start time of the starter before is shown, etc.
•
Press the yellow button PB2 (2) and the previous time is displayed once again.
•
To leave the menu you keep yellow push button PB2 (2) pressed until display (F)
shows blinking < PrInt > again.
If you want the first time to be shown, press the yellow push button PB2 (2) when the display
shows the last start number.