3
STEP 3:
Now you can reinstall the new hinge body. The new hinge body is longer (extends further to the front of
the oven unit) to accommodate the new glass door thickness and it allows the doors to fully open.
You will need to install the new hinge body onto the existing threaded studs used by the solid stainless
doors. Fasten the new hinge body with the wingnuts and tighten them up. (See illustration below)
NOTE:
The new hinge body has larger “obround” slots than the previous stainless door hinge body. This
will allow you to align the glass doors correctly when they are properly mounted. Follow Step 4 for align-
ment of the doors if necessary.
STEP 4: DOOR ALIGNMENT
(if necessary)
Once the hinge bodies have been installed on the left and right
front corners of the oven body, reinstall the new glass doors in the
same fashion as the stainless doors were removed on STEP 1.
If necessary, align the doors by loosening the wingnuts.
Start by loosening the bottom wingnut and slide the hinge body
left ◄ or right ► to align the glass door. This will cause the hinge
body to rotate on the top wingnut and help you to align the door
properly.
Close the class door to verify that the glass door is flat and paral-
lel to the bottom edge of the oven cavity opening.
Repeat this procedure with the opposite side body hinge and close
both doors to verify that they are level. Verify that the “gap” between both doors is parallel or that one
door is not higher than the other.
If necessary, you can loosen both wingnuts and slide the entire hinge body up ▲ or down▼ to adjust the
height of both glass doors.
One both doors are aligned correctly (same height and parallel to the bottom of the opening), tighten the
wignuts one more time to make sure they will stay in that position. Repeated heating cycles of the oven
will tighten wingnuts further.
NEW HINGE
BODY
REINSTALL THE WINGNUTS
HINGE
ALIGNMENT
VIEW FROM THE
INSIDE OF THE
UNIT
UP & DOWN
LEFT & RIGHT
HINGE
ADJUSTMENT
Содержание AXE-PZA-GD-KIT
Страница 1: ...1 ...
