3
ASSEMBLY PROCEDURE:
STEP 1:
Start by attaching the TOP and BOTTOM SHELVES to one
of the LEG ASSEMBLIES (shown on Figure 2 of Page 2)
with four 1/4”-20 x 3/8” Truss Head Screws.
NOTE:
Turn the unit upside down or on it’s side for this
step and
DO NOT
tighten up the screws until you are told
in this guide. Keep all screws and bolt lose until the end.
STEP 2:
Continue attaching the second LEG ASSEMBLY to the leg
stand. First install the exterior 1/4”-20 x 3/8” Truss head
screws to the TOP and BOTTOM SHELVES.
After the shelves have been attached, install 2 sets of
bolts, lock washers and nuts between each leg assembly.
NOTE:
Continue installing the remaining two LEG ASSEMBLIES
in the same fashion until all legs are assembled.
STEP 3:
With the entire unit UPSIDE DOWN, tighten up all the HEX
HEAD BOLTS and HEX NUTS using the 7/16” wrench.
STEP 4:
Install the casters on the leg assemblies and turn the entire
ALK-LS Leg Stand upright.
STEP 5:
With the Leg Stand upright (as shown on Figure 1) tighten
up all the TRUSS HEAD SCREWS form the TOP and
BOTTOM SHELVES with a # 2 Philips screwdriver.
The ALK-LS Leg Stand is now ready for use.
Figure # 3
1/4”-20 x 3/8” Screw
Figure # 4
1/4”-20 x 3/8” Screw
1/4”-20 x 5/8” Bolt
1/4” Lock Washer
1/4” Nut
CASTERS
Figure # 5
Содержание ALK-LS
Страница 1: ......
