Alfa Laval FrontLine WideGap 100, Инструкция по эксплуатации, Страница: 30 / 30

Maintenance
Clip-ad gaskets (MX25 and TL15)
The Clip-ad gasket represents a system with the conventional Clip-on fastening around the ports and fastening by means of
adhesive tape along the sides of the plates.
The use of the adhesive tape (GC1) is a simple way to obtain secure gasket positioning. It is adhered to the gasket groove
by means of a special tape gun, making it easy to apply the tape exactly where wanted.
Step 1
Open the heat exchanger (refer to “Opening” on page 20) and
remove the plate that is to have a new gasket.
Note!
Before opening the heat exchanger, check the warranty
conditions. If in any doubt, contact an Alfa Laval sales
representative. Refer to “Warranty conditions” on page
4 .
Step 2
Remove the old gasket.
Step 3
It is not necessary to remove old tape as the film is very thin.
Make sure, however, that the gasket groove is clean and dry.
Step 4
Adhere tape, using the tape gun.
Step 5
Attach the gasket to the plate. Slip the gasket prongs under the
edge of the plate.
Step 6
Close the heat exchanger according to “Closing” on page 25.
Glued gaskets
Use glue recommended by Alfa Laval. Separate gluing instructions will be delivered together with the glue.
Caution!
Other glues than those recommended can contain chlorides that can damage the plates.
Warning!
Do not use sharp tools when removing the glued gasket to avoid damage to the plates.
Document ID Language Edition
30 Instruction Manual - Plate Heat Exchangers 3490017599 EN 2016-06