24/33
ALFA IN a.s. ©
www.alfain.eu
RESET
1.
Pressing the V8
and
V20
buttons simultaneously for more than 3 seconds
will restore the factory settings and clear the stored JOBs (1 - 6).
COOLING UNIT TEST
1.
Pressing the V1
and
V20
buttons simultaneously for more than 3 seconds
will start the cooling unit.
2. Press any button to end the test.
3. If a flow meter (Hall-Effect) is used, a numerical value corresponding to the
coolant flow rate is displayed.
Error Err 2
occurs when the value is less
than 4 (this corresponds to approx. 0.7 l/min).
8
MIG/MAG SYNERGY WELDING
1. Select the
SYN
method according to SELECTION OF THE WELDING
METHOD.
2. The left display
V10
shows the machine power (current, wire feed speed,
material thickness), the right display
V11 shows the
voltage value. The
correction value (voltage, wire feed speed) or the choke value is shown on
display
V11
only during setup.
3. Press the
V8
button to switch the settings and display the machine
performance (current, wire feed speed, material thickness).
4. Set the machine output (current, wire feed speed, material thickness) using
the
V5
encoder.
5. The calibration menu can be set to disable the resetting of the correction
and change the choke when the machine power value changes.
6. Long press button
V13
to switch between voltage and wire feed speed
correction. Short press to switch between the set correction and the choke
value.
7. Adjust the voltage correction, wire feed rate or choke value using the
V16
encoder (if necessary).
8. Press the
V20
button to switch between
2T/4T/2T-stairs/4T-stairs
mode.
9. In the
2T-stairs/4T-stairs
mode, parameters cannot be set during welding.
10.
If a torch with remote control is connected, its display shows machine
power (current, wire feed speed, material thickness), correction (voltage,
wire feed speed), choke value or JOB. Use the
UP/DOWN
buttons to
adjust the displayed value,
use the MODE button
to switch between
functions.