Alf micatronic H19EN, Руководство пользователя

Страница: 31 / 40

29
4.1.4. Manuel Operation with Control Panel
4.2. Thermostat Control Model - H19EN
When the heater is plugged, H0 appears on the control panel
indicating that the heater is at stand by mode.
The 2
nd
digit of the power level indicates the increasing power
level by 1 to 5. The On/Off button which is located over the
ON/OFF
symbol, simply turns on and turns off
(Stand by)
the
heater.
To adjust the power, simply press the button over the
“increasing lines” symbol. Each press will increase the heating
power between 1 to 5 cycle.
Press the
ON/OFF
button to switch to stand by mode while
heater is operating. When heater is turned on with the same
button, it will continue to operate at the same level.
Unplug the power cord to disconnect the power of the heater.
If timer is set by the remote control, a warning red
LED
light appears continuously on the
screen.
Turn the button 0 to 1, to start the heater.
Adjust the thermostat button from low to high heating levels
for your preferred room temperature. Heater will operate in
low and high power cycles to keep the ambient temperature
at the desired level.
WARNING!
Heater continuously operates at low power until it is switched to “0”
position manually. Thus, it prevents you from possible dangers such as covering
the heater or wrong positioning by warning you with the visible glowing of the
heating element.
ALF_MIKA_TOWER_KK_140813.indd 29 27.09.2013 18:08