Description of Controls
S
TUDIO
24 R
EFERENCE
M
ANUAL
8 3
H
EADPHONE
L
EVEL
The LEVEL knob sets the overall level of the headphone output jack. The
Headphones get the same signal appearing at the Control Room outputs (but
independent of the Control Room’s level control).
H
EADPHONE JACK
The headphone jack on the top panel is designed for most stereo headphones. The
internal headphone amplifier outputs the maximum power allowed by safety
standards. The impedance and efficiency of the headphones will determine the
maximum volume available. Eight-ohm headphones may be louder at a given setting
than 150-ohm or 600-ohm headphones; however, there should be enough gain to
drive any dynamic headphone to reasonable levels if the mixer is being run properly.
GRP A
SSIGN
S
WITCHES
Press these switches if you want to record an effect (or other device plugged into the
Stereo Aux Return inputs) onto the multitrack. These switches route the signals from
the Stereo Aux Return jacks to the GRP 1/2 FADERs, with the left AUX input going
to GRP 1 and right AUX going to GRP 2. The Left input jack is mono, so if no plug is
inserted into the Right input, the left signal will be connected to both sides,
appearing in the center of the stereo image.
SOLO IN PLACE S
WITCH
The SOLO IN PLACE switches in the Stereo Aux Returns are a special kind of SOLO
switch to allow you to hear the effect returns in the Control Room mix. It sends the
return’s post-fader signal (and only that Monitor’s signal, if no other SOLO buttons
are pressed) directly to the Control Room monitors, cutting off any other signals to
the Control Room.
M
ONITOR
1/2 M
ASTER
This purple knob is the final overall level control for the Monitor 1/2 mix (the 12
controls to its left, plus the two in the Stereo Aux Return section). This controls the
level at the MONITOR OUTS 1 and 2 jacks on the back panel and the MON 1/2
switch in the Control Room section. Adjust the Monitor 1/2 Master for the correct
level feeding your external headphone or stage monitor amplifier. The nominal
(unity gain) setting for this control is approximately “2 o’clock.” Set it there if the
MON 1/2 mix will be used to add more inputs to the final mix using the LINK
switch, described below.
LINK TO L/R
SWITCH
This is a powerful switch that allows you to turn the Studio 24 into a 28-input stereo
mixer, instead of a 16-input mixer with an in-line monitor section. The LINK TO L/R
switch routes the MONITOR 1/2 MASTER signal to the Master L/R FADER.
Regardless of whether the LINK switch is up or down, the MONITOR 1/2 signal
always feeds the control room and headphone source switch, as well as the
Содержание Studio 24
