37
Step
Mode
Setting procedure
10
Temperature unit
Press [ WIND / + ] or [ NDX / - ] key to change the rain display unit between
˚C or ˚F
11
Wind speed unit
Press [ WIND / + ] or [ NDX / - ] key to change the unit in sequence: m/s
km/h knots mph
12
Baro unit
Press [ WIND / + ] or [ NDX / - ] key to change the unit in sequence: hPa
inHg mmHg
13
Rain unit
Press [ WIND / + ] or [ NDX / - ] key to change the rain display unit between
mm or in
14
Light intensity unit
Press [ WIND / + ] or [ NDX / - ] key to change the Light intensity unit in
sequence: Klux Kfc W/m².
15
Channel auto loop
Press [ WIND / + ] or [ NDX / - ] key to enable or disable channel auto loop
function
16
7-in-1 sensor point to
Press [ WIND / + ] or [ NDX / - ] key to select the sensor located hemisphere
(e.g. US and EU countries are also "N", Australia is "S")
Console will exit setting mode automatically, if no operation after 60 seconds.
SETTING ALARM TIME
1. In normal time mode, press and hold [ ALARM ] key for 2 seconds until the alarm hour digit flashes to enter alarm time
setting mode.
2. Press [ WIND / + ] or [ NDX / - ] key to change the value. Press and hold the key for quick-adjust.
3. Press [ ALARM ] key again to step the setting value to Minute with the Minute digit flashing.
4. Press [ WIND / + ] or [ NDX / - ] key to adjust the value of the flashing digit.
5. Press [ ALARM ] key to save and exit the setting.
6. When enabled the icon will be visible on the LCD.
ACTIVATING THE ALARM FUNCTION
1. In normal mode, press [ ALARM ] key to show the alarm time for 5 seconds.
2. When the alarm time displays, press [ ALARM ] key again to activate the alarm
function.
Alarm off
Alarm on
When clock reaches the alarm time, the alarm function will be trigered.
The alarm can be stopped by either of the following 4 operations
1. After 2 minutes of alarm the alarm will stop automatically while staying activated for the next day.
2. By pressing [SNOOZE / CONTRAST] key to enter snooze mode that will postpone the alarm by 5 minutes.
3. By holding [SNOOZE / CONTRAST] key for 2 seconds to stop the alarm and will activate again in the next day
4. By pressing [ ALARM ] key to stop the alarm and the alarm will activate again in the next day.
TEMPERATURE & HUMIDITY
The temperature and humidity reading are display on the outdoor and indoor / CH section.
If the reading is below the measurement range, it will show “LO”. If reading is above the measurement range,
it will show “HI”.
